I have attached the errors generated for you reference. This is my first time dealing with ANSYS APDL so I am a bit confused and lost. I did not know how I can make a circular electrodes that are Parallel to each other from top and bottom.n! positive electrodennsel,s,loc,y,20,40nnsel,r,loc,x,20,40nnsel,r,loc,z,0.5nd,all,volt,3000n! negative/ground electrodennsel,s,loc,y,20,40nnsel,r,loc,x,20,40nnsel,r,loc,z,0nd,all,volt,0) nI will share the command I used so far from the beginning until the end for your reference. And if you notice the shape of the electrodes is rectangular which I don't want. )nI tried to use the commands below to select the nodes but I still get the above errors I mentioned. Please check for an insufficientlynconstrained model.n orn*** WARNING *** CP = 8.531 TIME= 17:55:44nNode 1 on element 1 is unselected. All of the commands mentioned in this document are described in detail in the Mechanical APDL Command Reference. when I run the simulations I got the following errors n( *** WARNING*** CP = 52.094 TIME= 17:18:13nThere is at least 1 small equation solver pivot term (e.g., at the UZndegree of freedom of node 87422). Documentation open for further reference. I am learning everything from scratch to be honest and I think I am missing so many important/essentials commands that I am supposed to execute. Dear,nI tried to use the commands (nsel,CP and others) but I still get a lot of errors and I can not get the simulation done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |